XQ-2B manual metallographic specimen setting machine this machine is a mechanical setting machine, rotating the body outside the handwheel, through a pair of bevel gears to drive the body within the wire rod so that the pressing specimen of the lower die in the steel mold set up and down, thermosetting plastic with the inlaid specimen in the heating conditions. The molding pressure during sample preparation is automatically compensated by the spring fixed in the body of the machine, and the pressure of specimen pressing can be indicated by the signal lamp. This machine is equipped with intelligent digital display thermostat, set time, set temperature are displayed, the temperature sensor using thermocouples. This machine has the advantages of high sensitivity, high precision, temperature display, easy to observe and easy to operate.
The working environment：
1. altitude of not more than 1000 meters;
2. the surrounding medium temperature is not higher than +40 ℃, and not lower than -10 ℃. 3, the air in the relative humidity of not more than -10 ℃;
3. air in the relative humidity is not more than 85% (at 20 ℃);
4. there is no conductive dust, explosive gases, and corrosive gases that can seriously damage the metal and insulation;
5. No significant vibration and bumps
Technical parameters：
Model : XQ-2B(Φ25)
Specimen pressing specification：Φ25mm
Heater specification：800W
Temperature adjustment range：0-300℃
Timing control：0-99 minutes
Power supply：220V
Weight：32kg
